RAM TRUCK 2500 2010 Owner's Manual download pdf (Page 20)

PROGRAMMABLE FEATURES

Electronic Vehicle Information Center (EVIC) – If Equipped

• The EVIC can be used to program the following Personal Settings. Press the UP or

DOWN

button until SYSTEM SETUP displays, then press the SELECT button .

Scroll through the settings using the UP or DOWN button. Press the SELECT button to

change the setting.

• Select Language • Headlamps With Wipers

• Nav-Turn By Turn • Automatic High Beams – If Equipped

• Park Assist System • Wiper Mode – If Equipped

• Auto Door Locks • Easy Exit Seat – If Equipped

• Auto Unlock Doors • Tilt Mirror In Reverse

• Remote Unlock Sequence • Key-Off Power Delay

• RKE Linked To Memory • Illuminated Approach

• Remote Start Comfort Sys. • Hill Start Assist (HSA)

• Horn With Remote Start • Display Fuel Saver – If Equipped

• Horn With Remote Lock • Compass Variance

• Flash Lamps With Lock • Calibrate Compass

• Headlamp Off Delay

Key Fob Programmable Featur es

• The following features may also be programmed by using the Key Fob transmitter or

the ignition switch and driver's door lock switch.

NOTE: Pressing the LOCK button while you are inside the vehicle will activate the

Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated will

cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle Security

Alarm.

Unlock On First Press

• To unlock either the driver's side, or all doors, on the first press of the UNLOCK button:

• Press and hold the LOCK button for at least 4 seconds, but no longer than

10 seconds. Then, press and hold the UNLOCK button while still holding the LOCK

button.

• Release both buttons at the same time.

Auto Unlock Doors On Exit

• To have all of the vehicle doors unlock when any door is opened:

• Enter your vehicle, close all the doors and fasten your seat belt.

• Within 15 seconds, cycle the ignition switch from the OFF position to the ON

position a minimum of four times, ending in the OFF position (do not start the

engine).

• Within 30 seconds, press the driver’s door lock switch in the UNLOCK direction. A

single chime will indicate that programming is complete.

GETTING STARTED

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 95 96

No comments

RAM TRUCK 2500 2010 Owner's Manual Page 20