RAM TRUCK 2500 2010 Owner's Manual download pdf (Page 62)

• If in doubt about the correct tightness, have them checked with a torque wrench by

your authorized dealer or at a service station.

• Install the wheel center cap and remove the wheel blocks. Do not install chrome or

aluminum wheel center caps on the spare wheel. This may result in cap damage.

WARNING!

A loose tire or jack, thrown forward in a collision or hard stop, could endanger the

occupants of the vehicle. Always stow the jack parts and the spare tire in the places

provided.

• Secure the tire, jack, and tools in their proper locations.

• Position the wheel so that the valve stem is facing the ground. Slide the wheel retainer

through the center of the wheel and position it properly across the wheel opening.

NOTE: Aluminum wheels cannot be stored under the vehicle because the wheel retainer

will not fit through the wheel pilot hole. Secure the flat tire in the bed of the truck. Have

the flat tire repaired or replaced immediately.

JUMP-STARTING

• If your vehicle has a discharged battery it can be jump-started using a set of jumper

cables and a battery in another vehicle or by using a portable battery booster pack.

• Jump-starting can be dangerous if done improperly so please follow the procedures in

this section carefully.

NOTE: When using a portable battery booster pack follow the manufacturer’s operating

instructions and precautions.

WHAT TO DO IN EMERGENCIES

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 95 96

No comments

RAM TRUCK 2500 2010 Owner's Manual Page 62